McM
Jeantil Straw shredders & blowers

The P2000R range is designed for shredding and blowing straw for bedding. It can also be used to feed loose, chopped silage.

Mechanical shredding and blowing straw for bedding saves 20% in straw costs compared to traditional methods.

Unrolling or hand spreading lays down a thick compacted ‘mat’ of straw. The P2000R ‘fluffs up’ the straw and breaks up the fibrous outer surface of the stalks. As it is looser and more absorbent when it floats down onto existing bedding, less straw is needed.

The P2000R is not a straw chopper. Choppers cut the straw up too finely resulting in wastage. The jeantil rotor shreds the bale without chopping.

Available in two versions, the P2000R and the P2000R GT(with swivel spout)

3 point linkage mounted – a drawbar/wheel kit is an optional extra for smaller tractors (not ‘tele’version)
P2000R series straw blower

Shredding wrapped, round and square bales grass, hay or strw

drive greased by oil bath
Electronic control of moving floor speed
270 degree rotation with hydraulic motor, vertical orientation by electric ram

Hydraulic rear door raised by two doubleacting rams optional 1 metre door extension for square bales with retainer bar for the straw

Fixed drawbar with ring or clevis
Unbreakable knives can be removed and resharpened
Length      
Inside body length   B 2.70m
Maximum length Door closed A 1,70m
Maximum length Door open C 3.00m
Width      
Inside body width   D 1.35m
Overall width   E 1.79m
Width Chute folded back F 1.91m
width Chute folded out G 2.04
Height      
Inside body height   H 1.10m
Maximum height Chute folded back J 2.21m
Maximum height Chute folded out I 2.42m
Distribution height Min K 1.22m
Distribution height Max L 2.42m

Agriculture - Livestock - Jeantil straw shredders